I purchased an older model of this Troy Built Chipper Vac about 5 years ago.
THE CHIPPER: will handle limbs up to about 3/4 inch. Feeding limbs in I noticed it usually won’t finish pulling the last part of the limb into the chipper. I feed them in from the base of the limb first. This leaves the leaves going in last. So I just use the next limb to finish pushing in the last one this works pretty well.
THE FRONT VACUUM: works fairly well at picking up dry leaves. Once in a while it will leave some leaves behind and you have to go back over it (I admit my grass was a little high when that occured the leaves hung up in the grass so make sure your lawn is cut). My experience is it takes several passes to get pine needles vacuumed up but I admit I had left them on the ground awhile and that may have been a factor. I have never had the wide front vacuum clog. Another note about it is if you are vacuuming leaves off your driveway the vacuum will such up small gravel and you can hear it bashing around in the chipper. I am sure that’s not good for it (So I recommed blowing the leaves off the drivway and vacuuming them up).So to sum it up it does not do to bad. The wheels are ajustable in height.
THE VACUUM HOSE: does pretty good at getting in around flower beds and such (If you have a leave blower you could also just blow the leaves out of the flower bed and vacuum them up with the wide front vac). Sometimes when you are vacuuming with the hose it will clog. If a twig gets sucked up or you hit wet leaves it will clog. Usually the clog is where the hose connects to the deck. Just press the release remove the hose and pull the stuff out it is fairly easy.
MY COMPLAINT: The unit is NOT self propelled. This is a heavily constructed machine it has some weight to it. It is a little hard to push around and when that bag is getting full it is more tiring to push around!
OTHER: It does have a somewhat heavy pull start to it I believe it is to the fact that you are spinning the weight of the chipper blade with the engine to start it. But it has always started by the 2nd or 3rd pull for me. So if these problems are not a major drawback to you I would recommed the unit if you have a small area to vac. Me I am considering buying a self propelled.
Troy-Bilt 5.5 HP Chipper Shredder Vacuum #24B060F-766 Review
Published September 23, 2009 Tools Reviews Leave a CommentTags: 24B060F-766, Chipper, Shredder, Troy-Bilt, Vacuum, Wheels
Troy-Bilt 24B-060E766 CSV 060 24-Inch 190cc Briggs & Stratton 650 Series Gas Powered 3-in-1 Chipper/Shredder/Vacuum Review
Published September 18, 2009 Lawn mower reviews , Tools Reviews Leave a CommentTags: Branches, Chipper, engaging, experience, familar, Gas, handles, machine, Shredder, Troy-Bilt, Troy-Bilt 24B-060E766, truck, Vacuum
I purchased this chipper/vac about 6 weeks ago and have used it three times since. These are my observations,
1. The starter pull cord takes a lot of effort to pull, but does start in 1 or 2 pulls. If you have left a stick in the chipper chute that is engaging the blades, it is very hard to pull. If you don’t have average upper body strength you will have a difficult time starting this machine.
2. The run/stop lever is difficult to reach because it is located behind the bag. You can not read it because the bag is in the way, so become familar with the direction for run and stop prior to running, because you will need to reach in blindly to stop it.
3. The adjustment for the nozzle height, in my case, needs to be all the way up. I do not have the benefit of a perfectly flat yard, so, when I come across a high spot the edge of the nozzle digs in and divots the lawn. All the way up is the only way I can operate this machine.
4. When Troy-Bilt states in the agreement, shipper is not responsible to get this machine off the shippers truck, they mean it. When the tractor trailer came, I had to be inventive as to getting this 200 lb machine off his truck. The driver did help, but it was my responsibilty to come up with a way to get the large box to the ground.
5. Other reviewers have stated difficulty with the bag. I have found the bag to be a learning experience. What I mean is once you get the hang of it, you can install and remove it quickly and without much effort. I like the bottom zipper for dumping the leaves and the multiple grab handles.
6. The vac has good suction. Branches do need to be rather straight and have some thickness and weight to find their way to the blades on their own. It chips well.
7. My neighbors spend all day raking and I vac in the time it takes to mow the lawn.
8. I haven’t as of yet had the experience of vacuuming up a stone and still wonder if it is possible and what, if any, damage it could cause.
So far, I am pleased with this purchase. I never looked forward to raking up up least 50 bags of leaves. Uneven surfaces are a problem, but you find a way to deal with it eventually, it still beats raking.
Troy-Bilt 24A-204B766 CSV 206 24-Inch 206cc Briggs & Stratton 850 Series Gas Powered 3-in-1 Self Propelled Chipper/Shredder/Vacuum Review
Published September 14, 2009 Tools Reviews Leave a CommentTags: Briggs, Chipper, Christmas, company, dinner, factory, feeder, grinding, mulching, process, Shredder, Stratton, street, Troy-Bilt, Troy-Bilt 24A-204B766, Vacuum, yard
I have now been using the 6.5 HP Troy Built C/S/V for three months. To make this simple, I’ll get straight to the pro’s and cons…
Pro’s…
1) The factory did an excellent job of packaging and crating the unit for shipment
2) The unit feels substantial and this was reinforced for me as I went through the very simple set-up process (takes about an hour to unbox and set-up)
3) Directions for set-up were flawless
4) Once started, the unit does an excellent job of picking up dry leaves and twigs through the vaccuum nozzle — it cleared my 1/3 acre yard in about 2 hours (including the time it took me to get the refuse to the street for pick-up)
5) When the suction power of the nozzle is overhwelmed by leaves, it is very easy to unclog the nozzle — I just use a twig
6) I found that the unit hungrily accepted branches up to 2.5 inches in diameter (I measured) — the unit does start to bog down on branches larger than this
7) Does a fantastic job of mulching yard waste — I can’t say it does this to a 10:1 ratio like the company claims (how do they measure this?), but I am very please with how few lawn bags I am using this season
Cons…
1) This unit is EXTREMELY difficult to start. For context, I am 6′ 2″ and before that third helping of Christmas dinner, I weighed in around 235 lbs. My wife, 5′ 3″ and around 120 (if she reads this I’m a dead man!), was never able to start the unit. I would guess that the pull weight on the starter cord exceeds 60 lbs. Exascerbating the issue is the rather awkward position in which the pull starter is located.
2) Branches can get jammed in the feeder shoot, and the plunger is never quit long enough to drive a lot of branches to the grinding teeth. Freeing these items from the feeder tube can be a frustrating process.
3) Awkward position of zipper on the catch bag makes it difficult to transfer mulched waste into garbage bags
Net/net: If you have a lot of trees and want to save time and think you’re man enough to start it ; ) — BUY IT!
DeWalt DC9091 XRP 14.4-Volt 2.4 Amp Hour NiCad Pod Style Battery
Published November 20, 2008 Uncategorized Leave a CommentTags: Battery, cordless, Life, Memory, NiCad, nickel, Time
Step up to the extra power of the DeWALT14.4-volt XRP battery pack. This high-capacity NiCad (nickel cadmium) battery delivers 40 percent more run time than standard NiCads. That means you can work longer—drive more screws, bore more holes—and spend less time swapping out and recharging batteries.The XRP pack, which stands for eXtended Run-time Performance, will fit all of DeWALT’s 14.4-volt cordless tools and chargers, except its Univolt tools. Finally, remember to recycle your old batteries. –Joseph Truini
What’s in the Box
One rechargeable 14.4-volt XRP NiCad (nickel-cadmium) battery
Product Description
14.4V, XR Extended Run Time Battery Pack, High Capacity Battery, 40% More Run Time, Long Life, 1,200 Cycles, No Memory Effect, 2 Year Warranty
Technical Details
- DEWALT 14.4-volt XRP Ni-Cad battery pack; runs all DEWALT 14.4-volt tools (not Univolt)
- High-capacity batter with 40 percent more run-time than standard batteries
- Rugged plastic casing
- Battery; charger separate
- 5.8 by 3.2 by 7.2 inches; 1.8 pounds; 1-year warranty
Atlantic 8-Shelf Steel Multimedia Storage Rack
Published November 19, 2008 Home Entertainment Reviews Leave a CommentTags: Amazon, appeal, Atlantic, CD, DVD, Multimedia, Shelf, Storage
Product Features
- 8 adjustable-height shelves
- Holds up to 440 CDs or 228 DVDs or 120 VHS tapes
- Rugged steel construction
- Black finish
- Measures 24 x 48 x 6 inches (W x H x D)
Amazon.com Product Description
Say goodbye to clutter with Atlantic’s rugged and stylish 8-shelf multimedia storage rack. You can pack it with up to 440 CDs or 228 DVDs or 120 VHS tapes, or some combination of the three. You can adjust the shelving height to suit your media, and the rack is constructed of heavy-gauge steel for long life and countless rearrangements of your favorite music and movies.
Product Description
Atlantic is the pioneer in the home storage industry. Its comprehensive categories of products appeal to a broad range of consumers emphasizing quality, value and convenience. Atlantic has introduced fresh and innovative products the market yearns for and continues to strive to meet the demands of an ever-changing marketplace. The company takes pride in its revolutionary use of materials for its merchandise.Constructed of heavy gauge steel, this adjustable multi-media storage system will store your whole collection of DVDs.
Coleman Round Fireplace with Wheels and Cover
Published November 18, 2008 Fireplace Accessories Leave a CommentTags: Cover, fireplace, Home, Patio, Wheels
Product Description
Patio Fireplace with Wheels With Protective Cover-Easy Assembly 24-inch hinged cooking grate converts wood burning fireplace to a charcoal grill Add charcoal or wood easily through a hinged cooking grate and hinged doors PVC-coated leg caps prevent scraping of patio surfaces and wheels make for easy portability Weather-resistant porcelainized lid and base 7-year limited warranty
Product Description
Coleman Back Home, 28″ Round Patio Fireplace With Wheels, Black, With Cover, Wood Burning Fireplace, Wheels & Handles Allow The Fireplace To Be More Easily Moved, Weather Resistant Porcelain Lid & Base, Hinged Doors Allows Easy Access To Add Wood, Screen Assembly Requires Minimal Time For Set Up, Easily Removed, PVC Coated Leg Caps Prevent Scraping Of Patio Surfaces, Perfect For Patios, Backyards & Other Outdoor Activities, 7 Year Limited Warranty.
Customer Reviews
BY Happy Camper
We looked at various sites for an all black Coleman Round Fireplace with Wheels and Cover and found it here, for less!
The product arrived sooner than expected and was easy to put together. We have used our fireplace quite a bit and can even take it when we go camping. It also doubles as a barbeque!
By S.Baren
This product was exactly what I ordered. It arrived very promptly. I am very pleased with my order and would buy again. Thank you!
CharBroil 03505784 Firenzy Outdoor Fireplace with Screen
Published November 17, 2008 Fireplace Accessories Leave a CommentTags: Amazon, CharBroil, fireplace, hardware, Outdoor, Outdoor Fireplace, Review, Screen, summer, wood
After the warm sun sets and the evening turns cool, linger in the backyard in comfort beside the Firenzy Outdoor Fireplace from Charbroil. With see-through mesh screens on all sides, users can enjoy a view of the fire from every angle. Warm and bright, the outdoor fireplace offers a great centerpiece at a small summer pool party or while drinking cider after caroling in the neighborhood.With 334 square inches of space, the fireplace frame features heavy-duty 100-percent steel construction. Powder-coated for high temperature-resistance, the frame provides durability and functionality for fires built with wood, charcoal, or artificial logs. Charbroil also installed a log rack for user convenience. The four mesh side screens remove to allow users to stoke the fire, roast marshmallows, or clean out debris, while containing sparks. For enhanced safety, position the fireplace on a flat cement or dirt surface, away from tree branches and dry grass. Do not leave fires unattended and keep a bucket of water or hose near by for any unexpected flare-ups. This product requires assembly upon purchase. All necessary hardware comes enclosed with the fireplace. Charbroil offers a limited 90-day warranty. Upon shipping, the fireplace measures 30 by 21-1/4 by 7-1/4 inches and weighs 43 pounds upon shipping. –Jessica Reuling
From the Manufacturer
Enjoy the warmth and ambiance of a real wood burning fireplace on your patio or deck. The Firenzy outdoor fireplace from CharBroil is sure to be a great looking addition to any outdoor living area. With it’s modern looks, and useful features, this is sure to be an item that is featured in your feature outdoor events year round. Use it to relax after a long days work on a cool Summer evening, or to provide warmth on a cool Fall or Winter night. The Firenzy’s size means this outdoor fireplace will accomodate virtually any sized patio.
Product Description
An outdoor fireplace with 334 sq inches of burn area. Easily tend to the fire from 2 sides with removable screens. Accomodates standard size firewood. Features all-steel construction with heat-resistant paint for weatherability. Limited 1-year warranty. Fire pit measures 30 by 21-1/4 by 7-1/4 inches upon shipping and weighs 43 pounds; imported with limited 90-day warranty Outdoor fireplace for warmth and ambience from Char-Broil Fireplace features 100-percent steel construction with powder-coated finish for heat resistance; 4 mesh screens allow 360-degree view Built-in log rack for firewood, artificial logs, or coals; screens remove for adding wood, cleaning, or storage Some assembly required; all hardware provided